2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P1607 Cruise Control Input Processor

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.
DTC Code
DTC Detection Condition
Trouble Area
P1607
The ECM CPUs malfunction.
ECM

INSPECTION PROCEDURE


1. CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the engine switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the engine switch on (IG).

  1. Check for DTC.

    OK:
    P1607 is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P1442 Stuck Close in Secondary Air Injection Vacuum Switching Valve Bank 1 (+ P1445, P2441) (Sep 2011 – Dec 2011)P1613 Secondary Air Injection Driver Malfunction (Sep 2011 – Dec 2011) →