2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

C1626 Steering Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

This DTC is stored if the multi-media module receiver assembly receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.
DTC Code
DTC Detection Condition
Trouble Area
C1626
A fail flag is transmitted from the steering angle sensor.
  1. Steering sensor
  2. Multi-media module receiver assembly

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (Click here).


1. REPLACE STEERING SENSOR
  1. Replace the steering sensor with a normally functioning one (Click here).


NEXT


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1626 is not output.



NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK

END (STEERING SENSOR IS DEFECTIVE)


← C1625 Open or Short in Steering Angle Sensor +B (from Jan 2012)C1649 Lost Communication with VGRS ECU (from Jan 2012) →