2011-2013 Land Cruiser · Service Manual Brake

C1420 Acceleration Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

Refer to DTCs C1419 and C1435 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
  1. Sensor installation
  2. Acceleration sensor (Yaw rate sensor assembly)

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
After replacing the yaw rate sensor assembly, perform calibration (Click here).


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output (for LHD)
    B
    CAN DTC is output (for RHD)
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION
  1. Check that the yaw rate sensor assembly is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE SENSOR ASSEMBLY CORRECTLY (Click here)
OK

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)


← C1419 Acceleration Sensor Internal Circuit (+ C1435) (from Jan 2012)C1421 Open or Short in Master Cylinder Pressure Sensor (+ 6 more codes) (from Jan 2012) →