2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Multi-display and Television Camera Assembly

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the display signal circuit of the rear television camera.

WIRING DIAGRAM

E164519E08

INSPECTION PROCEDURE


1. INSPECT REAR TELEVISION CAMERA ASSEMBLY
E160211E02
Text in Illustration 
*1
Component with harness connected
(Rear Television Camera Assembly)
-
-
  1. Using an oscilloscope, check the waveform.

    Measurement Condition 
    Item
    Content
    Tester No. (Symbol)
    S5-2 (CV+) - S5-1 (CV-)
    Tool Setting
    0.2 V/DIV., 0.2 μS/DIV
    Condition
    Engine switch on (IG), shift lever moved to R

    OK:
    Pulse generation



NG
REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)
OK


2. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY

  1. E197554E01
    Disconnect the F66 display and navigation module display connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F66-6 (CA+) - F66-17 (CGND)
    Engine switch on (IG), shift lever moved to R
    5.8 to 6.5 V

Text in Illustration 
*1
Component with harness connected
(Display and Navigation Module Display)


NG
REPLACE MULTI-DISPLAY (Click here)
OK


3. INSPECT DISPLAY AND NAVIGATION MODULE DISPLAY - REAR TELEVISION CAMERA
  1. Disconnect the F66 display and navigation module display connector.

  1. Disconnect the S5 camera connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S5-4 (CB+) - F66-6 (CA+)
    Always
    Below 1 Ω
    S5-3 (CGND) - F66-17 (CGND)
    Always
    Below 1 Ω
    S5-2 (CV+) - F66-5 (V+)
    Always
    Below 1 Ω
    S5-1 (CV-) - F66-16 (V-)
    Always
    Below 1 Ω
    S5-4 (CB+) - Body ground
    Always
    10kΩ or higher
    S5-3 (CGND) - Body ground
    Always
    10kΩ or higher
    S5-2 (CV+) - Body ground
    Always
    10kΩ or higher
    S5-1 (CV-) - Body ground
    Always
    10kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Reverse Signal Circuit (from Jan 2012)Image from Camera for Rear View Monitor is Abnormal (from Jan 2012) →