INSTALLATION
Removal / installation · Vehicles built from Jan 2012
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. INSTALL MAIN SWITCH ASSEMBLY |
Attach the 2 claws to install the main switch assembly.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
w/o Multi-information Display:
Connect the connector.
w/ Multi-information Display:
Connect the 2 connectors.
Attach the 9 claws to install the finish panel.

Attach the 4 claws.

| 3. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Attach the 2 claws to install the panel garnish.

| 4. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH |
Connect the connectors and 2 clamps.

Attach the 8 claws to install the panel pad.
Install the screw.
Install the clip.
| 5. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
Attach the 7 claws to install the panel cushion.

| 6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Attach the 3 claws to install the panel garnish.

| 7. INSTALL INSTRUMENT SIDE PANEL LH |
![]() ![]() |
Attach the 6 claws to install the instrument side panel.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (Click here).

