INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1.
INSTALL FRONT SEATBACK HEATER ASSEMBLY LH |
 |
Set the seatback heater with the name stamp side facing the seatback cover.
Install the seatback heater with new tack pins.


| 2.
INSTALL FRONT SEPARATE TYPE SEATBACK COVER
|
 |
- Attach the fastening tape to install the seatback cover.
Using hog ring pliers, install new hog rings.
- NOTICE:
- Be careful not to damage the cover.
- When installing the hog rings, avoid wrinkling the cover.
- Connect the seatback cover bracket to the seatback pad.
| 3.
INSTALL SEATBACK COVER WITH PAD |
 |
Install the seatback cover with pad to the seatback frame.
- Install the seatback cover bracket to the seat frame with the nut.
-
Torque:
- 5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
- CAUTION:
- After the seatback cover with pad is installed, make sure the seatback cover bracket is not twisted.
- Attach the 9 hooks.
Using hog ring pliers, install new hog rings.
- NOTICE:
- Be careful not to damage the cover.
- When installing the hog rings, avoid wrinkling the cover.
- Connect the seat heater connector and attach the 2 wire harness clamps.
| 4.
INSTALL FRONT SEAT HEADREST SUPPORT
|
 |
Attach the 4 claws to install the 2 headrest supports.
| 5.
INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH
|
 |
Move the seatback board in the direction of the arrow to attach the 2 hooks and install the seatback board.
Install the 2 screws.
| 6.
INSTALL FRONT INNER SEAT CUSHION SHIELD LH
|
 |
Attach the 2 claws and clip to install the cushion shield.
Install the screw.
| 7.
INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
|
 |
Install the front seat inner belt assembly with the nut.
-
Torque:
- 42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
- NOTICE:
- Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.
Connect the connectors and attach the clamps.
| 8.
INSTALL FRONT SEAT CUSHION SHIELD LH
|
 |
- for Driver Side:
Connect the lumbar switch connectors.
Attach the 2 claws to install the cushion shield.
Install the 3 screws.
- Install the 2 screws.
Connect the 2 rubber bands to the 2 hooks.
| 9.
INSTALL RECLINING POWER SEAT SWITCH KNOB
|
 |
Attach the 2 claws to install the knob.
| 10.
INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
 |
Attach the 2 claws to install the knob.
| 11.
INSTALL FRONT SEAT ASSEMBLY LH |
 |
Install the front seat assembly (Click here).