2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH
  1. Set the seat cushion heater with the name stamp side facing the seat cushion cover.

  1. Install the seat cushion heater with new tack pins.

    B180732E01


2. INSTALL FRONT SEPARATE TYPE SEAT CUSHION COVER

B180733E01
  1. Using hog ring pliers, install the seat cushion cover to the seat cushion pad with new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, avoid wrinkling the cover.


3. INSTALL SEAT CUSHION COVER WITH PAD

  1. B180708
    Attach the hooks to install the seat cushion cover with pad.

  1. Bend the 2 seat frame claws downward.

  1. B180707
    Connect the seat heater control connector and attach the wire harness clamp.

  1. B180765
    for Front Passenger Side:
    Attach the 2 clamps to install connector holder.

  1. B180706
    Connect the seat heater connector and attach the 2 wire harness clamps.

  1. B180705
    Install the 2 clips.


4. INSTALL FRONT POWER SEAT SWITCH LH

B180704
  1. Install the switch with the 3 screws.

  1. w/ Seat Position Memory System:
    Connect the 2 connectors.

  1. w/o Seat Position Memory System:
    Connect the connector.


5. INSTALL FRONT INNER SEAT CUSHION SHIELD LH

B180703
  1. Attach the 2 claws and clip to install the cushion shield.

  1. Install the screw.


6. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH

B185875E01
  1. Install the front seat inner belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

  1. Connect the connectors and attach the clamps.


7. INSTALL FRONT SEAT CUSHION SHIELD LH

  1. B180700
    for Driver Side:
    Connect the lumbar switch connectors.

  1. Attach the 2 claws to install the cushion shield.

  1. Install the 3 screws.

  1. B180699
    Install the 2 screws.

  1. Connect the 2 rubber bands to the 2 hooks.


8. INSTALL RECLINING POWER SEAT SWITCH KNOB

B180734
  1. Attach the 2 claws to install the knob.


9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180735
  1. Attach the 2 claws to install the knob.


10. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat assembly (Click here).

← INSPECTION (from Jan 2012)INSTALLATION (from Jan 2012) →