INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the LHD vehicle and RHD vehicle.
- The procedures listed below are for the LHD vehicle.
- Use the same procedures for the LHD vehicle and RHD vehicle.
| 1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY |
![]() ![]() |
Install the amplifier with the screw.
Connect the connector.
| 2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL |
![]() ![]() |
Connect the connector.
Attach the 3 claws to install the lower No. 2 instrument panel finish panel.
Install the 4 bolts.
| 3. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() ![]() |
Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.
| 4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag) |
Connect the connector.

- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Attach the 4 claws to install the front passenger side knee airbag.
Install the 4 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 5. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag) |
![]() ![]() |
Attach the 4 claws to install the lower instrument panel.
Install the 2 bolts.
| 6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover) |
![]() ![]() |
Attach the 4 claws to install the No. 2 instrument panel under cover.
| 7. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH |
![]() ![]() |
Attach the 7 claws to install the lower instrument panel pad sub-assembly.
Install the clip and screw.
| 8. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION |
![]() ![]() |
Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.
| 9. INSTALL FRONT DOOR SCUFF PLATE RH |
w/ Sliding Roof:
Remove the front door scuff plate (Click here).
w/o Sliding Roof:
Remove the front door scuff plate (Click here).
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag) |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 11. CHECK SRS WARNING LIGHT (w/ Passenger Side Knee Airbag) |
Check the SRS warning light (Click here).







