2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LHD vehicle and RHD vehicle.
  2. The procedures listed below are for the LHD vehicle.


1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY

E154169
  1. Install the amplifier with the screw.

  1. Connect the connector.


2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

B180304
  1. Connect the connector.

  1. Attach the 3 claws to install the lower No. 2 instrument panel finish panel.

  1. Install the 4 bolts.


3. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

B182550
  1. Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.


4. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

  1. B189607E01
    Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 4 claws to install the front passenger side knee airbag.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


5. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

B180302
  1. Attach the 4 claws to install the lower instrument panel.

  1. Install the 2 bolts.


6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B182552
  1. Attach the 4 claws to install the No. 2 instrument panel under cover.


7. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

B180005
  1. Attach the 7 claws to install the lower instrument panel pad sub-assembly.

  1. Install the clip and screw.


8. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION

B182501
  1. Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.


9. INSTALL FRONT DOOR SCUFF PLATE RH
  1. w/ Sliding Roof:
    (Click here)

  1. w/o Sliding Roof:
    (Click here)


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


11. CHECK SRS WARNING LIGHT (w/ Passenger Side Knee Airbag)
(Click here)
← INSTALLATION (Sep 2011 – Dec 2011)ON-VEHICLE INSPECTION (from Sep 2011) →