2011-2013 Land Cruiser · Service Manual Power Source / Network

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL NETWORK GATEWAY ECU

E154163
  1. Install the ECU with the nut.

  1. Connect the connector.


2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

B180304
  1. Connect the connector.

  1. Attach the 3 claws to install the lower No. 2 instrument panel finish panel.

  1. Install the 4 bolts.


3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB

B182549
  1. Attach the 2 claws to install the instrument panel box door knob.


4. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

B182550
  1. Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.


5. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

  1. B189607E01
    Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 4 claws to install the front passenger side knee airbag.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


6. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

B180302
  1. Attach the 4 claws to install the lower instrument panel.

  1. Install the 2 bolts.


7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B182552
  1. Attach the 4 claws to install the No. 2 instrument panel under cover.


8. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
  1. w/o Console Box Lid:

    1. Install the lower instrument panel pad sub-assembly RH (Click here).

  1. w/ Cool Box:

    1. Install the lower instrument panel pad sub-assembly RH (Click here).

  1. w/o Cool Box:

    1. Install the lower instrument panel pad sub-assembly RH (Click here).


9. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
  1. w/o Console Box Lid:

    1. Install the No. 1 instrument panel finish panel cushion (Click here).

  1. w/ Cool Box:

    1. Install the No. 1 instrument panel finish panel cushion (Click here).

  1. w/o Cool Box:

    1. Install the No. 1 instrument panel finish panel cushion (Click here).


10. INSTALL FRONT DOOR SCUFF PLATE RH
  1. w/ Sliding Roof:
    Install the front door scuff plate (Click here ).

  1. w/o Sliding Roof:
    Install the front door scuff plate (Click here).


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


12. CHECK SRS WARNING LIGHT (w/ Passenger Side Knee Airbag)
  1. Check the SRS warning light (Click here).

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →