After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
3.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Loosen the radiator drain cock plug.
Remove the radiator reservoir cap to drain the coolant in the radiator.
Loosen the oil filter bracket drain cock plug to drain the coolant in the engine.
Tighten the radiator drain cock plug by hand.
Tighten the oil filter bracket drain cock plug.
Torque:
13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
7.
REMOVE UPPER RADIATOR SUPPORT SEAL
Remove the 7 clips and radiator support seal.
8.
REMOVE NO. 3 ENGINE ROOM WIRE
Disconnect the 4 wire harness clamps.
Remove the 2 nuts and No. 3 engine room wire.
9.
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Remove the 2 nuts and No. 1 engine cover.
10.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Loosen the hose clamp and disconnect the connector.
Using a clip remover, detach the 3 clamps and remove the air cleaner cap.
11.
REMOVE NO. 1 AIR CLEANER HOSE
Loosen the hose clamp and remove the No. 1 air cleaner hose.
12.
REMOVE INTAKE AIR CONNECTOR
Disconnect the 2 connectors from the viscous heater and water temperature sensor.
Using a clip remover, detach the 3 wire harness clamps.
Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.
13.
REMOVE V-RIBBED BELT
Loosen the lock nut and turn the bolt counterclockwise.
Remove the V-ribbed belt.
14.
REMOVE VANE PUMP OIL RESERVOIR ASSEMBLY
Insert a screwdriver between the reservoir and oil reservoir bracket, push the claw, and then disconnect the reservoir by pulling it upwards.