2011-2013 Land Cruiser · Service Manual Suspension

C1787 Forward/Rearward/Sideways G Sensor Communication Error

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The suspension control ECU receives signals from the yaw rate sensor via CAN communication.
DTC Code
Detection Condition
Trouble Area
C1787
While the engine switch is on (IG), the yaw rate sensor malfunction signal is detected for 1 second or more.
  1. Vehicle stability control system
  2. Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check if a yaw rate sensor malfunction DTC is output under the vehicle stability control system (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. CHECK DTC
  1. Check for DTCs.

    Result 
    Result
    Proceed to
    DTC C1787 is output
    A
    DTC C1787 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1787 Forward/Rearward/Sideways G Sensor Communication Error (Sep 2011 – Dec 2011)C1791 Absorber Control Switch Circuit (Test Mode DTC) (Sep 2011 – Dec 2011) →