2011-2013 Land Cruiser · Service Manual Brake

Skid Control Buzzer Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The skid control buzzer sounds while the accumulator pressure is abnormally low or an abnormality causing low fluid pressure occurs, and the skid control buzzer sounds intermittently while the VSC and hill-start assist control is activated.

WIRING DIAGRAM

C173348E14

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer ON/OFF
    The buzzer can be heard.

  1. Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.

    Result 
    Result
    Proceed to
    Buzzer sounds/stops
    A
    Buzzer does not sound or sounds constantly
    B



A
USE SIMULATION METHOD TO CHECK (Click here)
B


2. INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL)

  1. C216859E11
    Disconnect the E5 skid control buzzer connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E5-2 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT SKID CONTROL BUZZER

  1. C208381E10
    Apply battery voltage to the skid control buzzer, and check that the buzzer sounds.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) voltage - Terminal 2 (IG1)
    Skid control buzzer sounds.
    Battery negative (-) voltage - Terminal 1 (BZ)



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)

  1. C249028E02
    Disconnect the A24 skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-30 (BZ) - E5-1 (BZ)
    Always
    Below 1 Ω
    A24-30 (BZ) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    NG
    A
    OK
    for LHD
    B
    for RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Turn Assist Indicator Light Circuit (from Jan 2012)Skid Control Buzzer Circuit (from Jan 2012) →