INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the LHD vehicle and RHD vehicle.
- The procedures listed below are for the LHD vehicle.
| 1.
INSTALL AIR CONDITIONING CONTROL ASSEMBLY |
 |
Connect the connectors.
- Insert the radio receiver and attach the 5 claws on its backside.
- NOTICE:
- When inserting the radio receiver, do not press the knobs on it.
| 2.
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
|
 |
Connect the connectors.
Attach the 7 claws to install the lower center instrument cluster finish panel sub-assembly.
| 3.
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
|
 |
Attach the 7 claws to install the lower instrument panel pad sub-assembly.
Install the clip and screw.
| 4.
INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
|
 |
Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.
| 5.
INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
|
 |
Connect the connectors and attach the 2 clamps.
Attach the 8 claws to install the lower instrument panel pad sub-assembly.
Install the clip and screw.
| 6.
INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
|
 |
Attach the 7 claws to install the No. 2 instrument panel finish panel cushion.
| 7.
INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET |
 |
w/ Cassette Tape Player:
Install the radio receiver assembly with bracket (Click here).
w/o Multi-display:
Install the radio receiver assembly with bracket (Click here).
| 8.
INSTALL NO. 1 CENTER INSTRUMENT CLUSTER FINISH PANEL
|
 |
Connect the connector.
Attach the 10 claws to install the No. 1 center instrument cluster finish panel.
| 9.
INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
Connect the connector.
Attach the 6 claws to install the No. 4 instrument panel register.
| 10.
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
Connect the connector.
Attach the 6 claws to install the No. 3 instrument panel register.
| 11.
INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY
|
 |
Attach the 8 claws to install the opening cover.
| 12.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).