INSTALLATION
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1. INSTALL FUEL SENDER GAUGE ASSEMBLY |
Install a new gasket to the sender gauge.
Install the sender gauge with the 5 screws.
- Torque:
- 1.5 N*m{ 15 kgf*cm , 13 in.*lbf }
- NOTICE:
- Be careful not to bend the arm of the fuel sender gauge.
Connect the sender gauge connector.
| 2. INSTALL REAR FLOOR SERVICE HOLE COVER |
Install the service hole cover with new butyl tape.
| 3. INSTALL REAR NO. 7 AIR DUCT |
Attach the 4 clips to install the air duct.

- HINT:
- Attach the clips in the order shown in the illustration.
| 4. INSTALL REAR FLOOR MAT ASSEMBLY |
Attach the 5 clips to install the floor mat.
| 5. INSTALL REAR NO. 2 SEAT ASSEMBLY |
for Face to Face Seat Type:
Install the rear No. 2 seat assembly (Click here).
except Face to Face Seat Type:
Install the rear No. 2 seat assembly (Click here).
| 6. INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side) |
| 7. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side) |
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
