Home › Engine / Hybrid / EV System › 1GR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)
REMOVAL
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
1.
PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here ).
2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here ).
3.
REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)
(Click here )
4.
REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)
(Click here )
5.
REMOVE REAR NO. 2 SEAT ASSEMBLY
for Face to Face Seat Type (Click here )
except Face to Face Seat Type (Click here )
6.
REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
w/ Sliding Roof (Click here )
w/o Sliding Roof (Click here )
7.
REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
w/ Sliding Roof (Click here )
w/o Sliding Roof (Click here )
8.
REMOVE REAR FLOOR MAT ASSEMBLY
w/ Rear Air Conditioning System: Detach the 5 clips and fold back the floor mat toward the front of the vehicle.
HINT:
Fold back the floor mat so that the rear No. 7 air duct can be removed.
w/o Rear Air Conditioning System: Detach the 5 clips and fold back the floor mat toward the front of the vehicle.
HINT:
Fold back the floor mat so that the service hole cover can be removed.
9.
REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)
Detach the 4 clips and remove the air duct.
10.
REMOVE REAR FLOOR SERVICE HOLE COVER
11.
REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the sender gauge connector.
Remove the 5 screws and sender gauge.
NOTICE:
Be careful not to bend the arm of the fuel sender gauge.
Remove the gasket from the sender gauge.