2011-2013 Land Cruiser · Service Manual Suspension

C1784 Steering Angle Sensor Communication Error

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The steering sensor signal is sent to the suspension control ECU through the CAN communication system. When there is a communication malfunction, it will be detected by the diagnosis function.
DTC Code
Detection Condition
Trouble Area
C1784
A steering angle sensor signal malfunction is detected, or the steering angle sensor power malfunction signal is detected for 5 seconds or more.
  1. Vehicle stability control system
  2. Suspension control ECU

INSPECTION PROCEDURE

NOTICE:
  1. Before performing troubleshooting, inspect the connectors of related circuits.
  2. If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).


1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check if a steering sensor malfunction DTC is output under the vehicle stability control system (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. CHECK DTC
  1. Check for DTCs.

    Result 
    Result
    Proceed to
    DTC C1784 is output
    A
    DTC C1784 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SUSPENSION CONTROL ECU (Click here)


← C1783 Speed Signal Communication Error (from Jan 2012)C1784 Steering Angle Sensor Communication Error (from Jan 2012) →