U1102 Lost Communication with Radar Sensor
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The distance control ECU sends the vehicle speed and estimated curve information to the millimeter wave radar sensor. The millimeter wave radar sensor sends information about whether another vehicle is present in front of the vehicle, the distance between the vehicles, relative speed, etc. to the distance control ECU. The distance control ECU sends this information to the ECM and performs control of cruise control.| DTC Code |
DTC Detection Condition |
Trouble Area |
| U1102 |
The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the data sent from the distance control ECU to the millimeter wave radar sensor is abnormal. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When the distance control ECU is replaced with a new one, initialization must be performed (Click here).
- When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (Click here).
- As it is possible that this DTC was stored due to a bad connection of a connector, make sure to check that each connector is connected securely.
- When the distance control ECU is replaced with a new one, initialization must be performed (Click here).
| 1. CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - MILLIMETER WAVE RADAR SENSOR) |
Disconnect the A56 millimeter wave radar sensor connector.

Disconnect the E108 distance control ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A56-3 (LRDD) - E108-22 (LRDD)
Always
Below 1 Ω
E108-22 (LRDD) - Body ground
Always
10 kΩ or higher
A56-2 (SGND) - Body ground
Always
10 kΩ or higher
E108-10 (SGND) - Body ground
|
|
||||
| OK | |
| 2. REPLACE DISTANCE CONTROL ECU |
Replace the distance control ECU with a new one (Click here).
Perform initialization (Click here).
| NEXT | |
| 3. CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM) |
Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
Clear the DTCs (Click here).
Perform the following to make sure the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 50 km/h (30 mph) or more.
Turn the cruise control main switch on.
Push the -SET switch to activate the dynamic radar cruise control.
Check for DTCs (Click here).
- OK:
- DTC U1102 is not output.
|
|
||||
| OK | ||
| ||
