2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

Washer Signal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The distance control ECU detects washer operation. Cruise control will be canceled by the distance control ECU if the windshield wipers operate in HI or LO mode.

WIRING DIAGRAM

E158906E03

INSPECTION PROCEDURE


1. CHECK WASHER MOTOR (OPERATION)
  1. Check that the front washer operates (Click here).

    OK:
    Washer function is normal.



NG
GO TO WIPER AND WASHER SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)

  1. E158907E03
    Disconnect the E108 distance control ECU connector.

  1. Disconnect the E15 windshield wiper switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    E108-3 (WASH) - E15-3 (WF)
    Always
    Below 1 Ω
    E15-3 (WF) - Body ground
    Always
    10 kΩ or higher
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    E108-3 (WASH) - E15-1 (WF)
    Always
    Below 1 Ω
    E15-1 (WF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Distance Control Switch Circuit (from Jan 2012)Cruise Main Indicator Light Circuit (from Jan 2012) →