CB-13 USB Over Current Detection
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| CB-13 |
USB device or "iPod" overcurrent malfunction |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the engine switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the engine switch on (ACC).
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| NEXT | |
| 2. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3. RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC occurs again.
- HINT:
- If DTCs are detected frequently, replace the multi-media interface ECU.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
| 4. INSPECT MULTI-MEDIA INTERFACE ECU |
Disconnect the m1 No. 1 stereo jack adapter assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
m1-1 (UPO) - m1-4 (UJSG)
Always
5 V
Text in Illustration *1
Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)
|
|
||||
| OK | ||
| ||
| 5. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER) |
Disconnect the L45 multi-media interface ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
L45-1 (UPO) - m1-1 (UPO)
Always
Below 1 Ω
L45-4 (UESG) - m1-4 (UJSG)
Always
Below 1 Ω
m1-1 (UPO) - Body ground
Always
10 kΩ or higher
m1-4 (UJSG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
