2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

CB-13 USB Over Current Detection

Diagnostic trouble codes · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-13
USB device or "iPod" overcurrent malfunction
  1. USB device or "iPod"
  2. No. 1 stereo jack adapter assembly
  3. Wire harness or connector
  4. Multi-media interface ECU

WIRING DIAGRAM

E249768E01

INSPECTION PROCEDURE


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the engine switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the engine switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE

4. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E194160E05
    Disconnect the m1 No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    m1-1 (UPO) - m1-4 (UJSG)
    Always
    5 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)

5. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - NO. 1 STEREO JACK ADAPTER)
  1. Disconnect the L55 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L55-1 (UPO) - m1-1 (UPO)
    Always
    Below 1 Ω
    L55-4 (UESG) - m1-4 (UJSG)
    Always
    Below 1 Ω
    m1-1 (UPO) - Body ground
    Always
    10 kΩ or higher
    m1-4 (UJSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)


← CB-13 USB Over Current Detection (Sep 2011 – Dec 2011)CB-43 USB Device Class/Protocol Error (+ CB-44, CB-50, CB-51, CB-7D) (Sep 2011 – Dec 2011) →