DVD Image Signal Circuit between Radio Receiver and Navigation ECU
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
This circuit sends a DVD image signal from the radio receiver assembly to the display and navigation module display.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - DISPLAY AND NAVIGATION MODULE DISPLAY) |
Disconnect the F56 radio receiver assembly connector.
Disconnect the F66 display and navigation module display connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F56-8 (NTSC) - F66-9 (VV+)
Always
Below 1 Ω
F56-22 (GND) - F66-20 (VV-)
Always
Below 1 Ω
F56-8 (NTSC) - Body ground
Always
10 kΩ or higher
F56-22 (GND) - Body ground
Always
10 kΩ or higher
F56-7 (SLD) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT RADIO RECEIVER ASSEMBLY (DVD IMAGE SIGNAL) |
Reconnect the F56 radio receiver assembly connector.

Check the waveform according to the table below.

Oscilloscope Waveform Item
Content
Measurement terminal
F56-8 (NTSC) - Body ground
Measurement setting
200 mV/DIV,. 10 μs/DIV.
Condition
DVD display is on
- HINT:
- The video waveform changes according to the image output from the radio receiver assembly to the display and navigation module display, but the synchronization signal does not change.
Text in Illustration *1
Component with harness connected
(Radio Receiver Assembly)
*2
Synchronization Signal
*3
Video Waveform
|
|
||||
| OK | ||
| ||
