C1337/37 Diameter of the Tire is not Uniform
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1337/37 |
When either of the following conditions is detected:
|
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK TIRE SIZE |
Check tire size and condition of all 4 wheels.
- OK:
- Condition of all 4 wheels is normal and tire size is same.
|
|
||||
| OK | |
| 2. INSPECT SPEED SENSOR ROTOR |
Check the front speed sensor rotors (Click here) and rear speed sensor rotors (Click here).
Result Result
Proceed to
OK
A
NG
Front speed sensor
B
Rear speed sensor
C
|
|
||||
|
|
||||
| A | |
| 3. INSPECT SPEED SENSOR |
Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).
Result Result
Proceed to
OK
A
NG
Front speed sensor
B
Rear speed sensor
C
|
|
||||
|
|
||||
| A | |
| 4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SPEED SENSOR) |
Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).
|
|
||||
| OK | |
| 5. RECONFIRM DTC |
Clear the DTCs (Click here).
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is not output
A
DTC is output
for LHD
B
for RHD
C
|
|
||||
|
|
||||
| A | ||
| ||
