2011-2013 Land Cruiser · Service Manual Brake

C120A ECU Initial Setting Incomplete

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

After replacing the skid control ECU (master cylinder solenoid) or clearing the system information stored in the skid control ECU (master cylinder solenoid), the system information must be stored in the skid control ECU (master cylinder solenoid) again. The system information is automatically stored in the skid control ECU (master cylinder solenoid) when the system enters test mode. If the system information is not stored in the skid control ECU (master cylinder solenoid), DTC C120A is stored.
DTC Code
DTC Detection Condition
Trouble Area
C120A
The system information is not stored in the skid control ECU.
  1. Calibration not performed
  2. Skid control ECU (Master cylinder solenoid)

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).


1. PERFORM CALIBRATION
  1. Perform calibration (Click here).

    NOTICE:
    If a DTC is output after replacing the master cylinder solenoid, it is possible that calibration has not been performed or the zero point calibration data was not cleared when calibration was performed.


NEXT


2. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← C1203/53 ECM Communication Circuit Malfunction (Sep 2011 – Dec 2011)C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (from Jan 2012) →