C1203/53 ECM Communication Circuit Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
The circuit is used to send control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU via the CAN communication system.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1203/53 |
The engine/drivetrain specification and/or destination information from the ECM does not match the skid control ECU data. |
ECM |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC (FOR ENGINE CONTROL SYSTEM) |
Check if the engine control system DTC is output (for 2UZ-FE: Click here/ for 1VD-FTV: Click here/ for 3UR-FE: Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
- HINT:
- Refer to the ECM installation procedures:
- for 2UZ-FE (Click here)
- for 1VD-FTV (Click here)
- for 3UR-FE (Click here)
- Refer to Engine Control (How to Proceed with Troubleshooting):
- for 2UZ-FE (Click here)
- for 1VD-FTV (Click here)
- for 3UR-FE (Click here)
- Refer to the ECM installation procedures:
|
|
||||
| A | ||
| ||
