2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

B1575 GVIF Disconnected (from EMV/MM Integrated Device to Multi Display)

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
B1575
GVIF disconnected (from Multi-media module receiver assembly to Multi-display assembly)
  1. Harness or connector (GVIF cable)
  2. Multi-media module receiver assembly

INSPECTION PROCEDURE


1. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2. CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK HARNESS AND CONNECTOR (GVIF CABLE)
  1. Check that the digital signal lines between the multi-display assembly and parking assist ECU are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.

    OK:
    There are no installation problems.



NG
REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
OK


4. REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
  1. Replace the harness and connector (GVIF cable) with a new or normally functioning one.


NEXT


5. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


6. CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK

END (GVIF CABLE IS DEFECTIVE)


← B1574 GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device) (from Jan 2012)B1579 Voice Recognition Microphone Disconnected (from Jan 2012) →