89465
1.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Temporarily install the sensor to the front exhaust pipe by hand.
Using SST, tighten the heated oxygen sensor.
| *1 | Fulcrum Length |
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
Attach the clamp and connect the heated oxygen sensor connector.
89465
2.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Temporarily install the sensor to the front No. 2 exhaust pipe by hand.
Using SST, tighten the heated oxygen sensor.
| *1 | Fulcrum Length |
Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
Connect the heated oxygen sensor connector.
37117
3.INSTALL PROPELLER SHAFT HEAT INSULATOR
4.INSPECT FOR EXHAUST GAS LEAK