Refer to DTC P0100 (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>P0100).
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
|---|---|---|
| After warming up engine, idle engine for 20 seconds, then maintain engine at 3000 rpm for 20 seconds | After the engine is warmed up, condition (a) continues for more than 10 seconds when idling (2 trip detection logic):
(a) Mass air flow meter output is more than 4.4 V. |
Mass air flow meter |
| Conditions (a) and (b) continue for more than 10 seconds with the engine speed at 1250 rpm or more (2 trip detection logic):
(a) VTA is more than 0.1 V. (b) Mass air flow meter output is less than 0.7 V. |
| DTC No. | Data List |
|---|---|
| P0101 | ·
MAF ·
Actual EGR Valve Pos. ·
Actual EGR Valve Pos. #2 ·
Actual Throttle position ·
Actual Throttle position #2 |
If DTC P0101 is stored, either of the following symptoms may appear:
As the ECU mistakenly determines that there is less air than the actual intake air amount, EGR is decreased to match the target EGR.
Combustion noise worsens
As the ECU mistakenly determines that there is more air than the actual intake air amount, EGR is increased to match the target EGR):
Misfire
White smoke
Black smoke
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| P0101 and other DTCs are output | A |
| P0101 is output | B |
If codes other than P0101 are output, perform troubleshooting for those DTCs first.
B
A
(See pageEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>DIAGNOSTIC TROUBLE CODE CHART)
Check the air induction system for vacuum leakage (See page Engine / Hybrid System>1VD-FTV (INTAKE / EXHAUST)>INTAKE SYSTEM>ON-VEHICLE INSPECTION).
No leakage from air induction system.
OK
NG
Replace the mass air flow meter (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>MASS AIR FLOW METER (w/o DPF)>REMOVAL).
NEXT
NEXT
Connect the intelligent tester to the DLC3.
Clear the DTCs (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>DTC CHECK / CLEAR).
Turn the ignition switch off.
Start the engine.
After warming up the engine, idle the engine for 20 seconds, then maintain the engine at 3000 rpm for 20 seconds.
Confirm that the DTC is not output again.
Perform the following procedure using the tester to determine whether or not the DTC judgment has been carried out.
Enter the following menus: Powertrain / Engine / Utility / All Readiness.
Input DTC P0101.
Check that STATUS is NORMAL. If STATUS is INCOMPLETE or UNKNOWN, maintain the engine at 3000 rpm for 30 seconds and then idle the engine for 5 minutes.
NEXT