Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255003 CRANKSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the crankshaft position sensor.




b.

Install the crankshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 88320 2.INSTALL COOLER COMPRESSOR ASSEMBLY