Home › Power Source / Network › 1GR-FE (BATTERY / CHARGING) › GENERATOR(for 130 A Type) › 2014.08–2015.08
RM2660E _57 Power Source / Network _052832 1GR-FE BATTERY / CHARGING _0255521 GENERATOR(for 130 A Type) A

1GR-FE BATTERY / CHARGING  GENERATOR(for 130 A Type)  INSTALLATION  


PROCEDURE

Hide 27020 1.INSTALL GENERATOR ASSEMBLY

a.

Install the generator bracket to the generator with the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Install the generator with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Connect the generator bracket with the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


d.

Connect the wire harness clamp bracket with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Connect the generator wire to terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


f.

Close the terminal cap.


g.

Connect the generator connector.


Hide 53783 2.INSTALL FRONT FENDER APRON TRIM PACKING B

Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 7.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).