22030
1.INSTALL THROTTLE BODY ASSEMBLY
Install the 2 water by-pass hoses to the throttle body.
Install a new gasket to the intake air surge tank.
| *1 | Groove |
| *2 | Protrusion |
| *a | Surge Tank Side |
| *b | Throttle Body Side |
Align the protrusion of the gasket with the groove of the intake air surge tank.
Install the throttle body with the 4 bolts.
Connect the throttle position sensor and control motor connector.
Connect the 2 water by-pass hoses.
2.ADD ENGINE COOLANT
17880
3.INSTALL AIR CLEANER HOSE ASSEMBLY
4.INSPECT FOR COOLANT LEAK
5.CHECK THROTTLE BODY ASSEMBLY
51405A
6.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
53806
7.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
8.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
9.PERFORM INITIALIZATION
Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.
Disconnect the cable from the negative (-) battery terminal. Wait at least 60 seconds and reconnect the cable.
Turn the engine switch on (IG) without operating the accelerator pedal.
If the accelerator pedal is operated, perform the above steps again.
Connect the intelligent tester to the DLC3 and clear the DTCs (See page Engine / Hybrid System>3UR-FE (ENGINE CONTROL)>SFI SYSTEM(w/o Secondary Air Injection System)>DTC CHECK / CLEAR).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
| Condition | Engine Idle Speed |
|---|---|
| A/C switched off | 650 to 750 rpm |
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in N or P.
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Volt %. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.
11209
10.INSTALL V-BANK COVER SUB-ASSEMBLY