Home › Engine / Hybrid System › 3UR-FE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052777 3UR-FE ENGINE MECHANICAL _0255048 REAR CRANKSHAFT OIL SEAL A

3UR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 32101 4.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 11381A 5.REMOVE REAR CRANKSHAFT OIL SEAL

a.

Using a knife, cut off the lip of the oil seal.


b.
A236990E01
0.429,1.466 0.617,1.660 0.188,0.194 10 *1

Using a screwdriver, pry out the oil seal.

Text in Illustration
*1 Cut Position

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.