Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052783 1VD-FTV FUEL _0255119 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) A

1VD-FTV FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


a.

Disconnect the cables from the negative (-) main battery and sub-battery terminals.


Hide 71300S 3.REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

Hide 71400S 4.REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

Hide 5.REMOVE REAR NO. 2 SEAT ASSEMBLY

a.

for Face to Face Seat Type:

Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).


b.

except Face to Face Seat Type:

Remove the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL).


Hide 71845B 10.REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

Hide 62520P 11.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

a.

w/ Sliding Roof:

Remove the front quarter trim panel assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL).


b.

w/o Sliding Roof:

Remove the front quarter trim panel assembly LH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL).


Hide 62510P 12.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

a.

w/ Sliding Roof:

Remove the front quarter trim panel assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL).


b.

w/o Sliding Roof:

Remove the front quarter trim panel assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL).


Hide 87217B 13.REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)

Hide 87174 14.REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

Hide 58570B 15.SEPARATE REAR FLOOR MAT ASSEMBLY

A176328

a.

w/ Rear Air Conditioning System:

Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

HINT:

Fold back the floor mat so that the rear No. 7 air duct can be removed.



b.

w/o Rear Air Conditioning System:

Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

HINT:

Fold back the floor mat so that the service hole cover can be removed.



Hide 87212L 16.REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)

a.
A176392

Detach the 4 clips and remove the air duct.


Hide 58325E 17.REMOVE REAR FLOOR SERVICE HOLE COVER

A176326

Hide 83320B 18.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A176327

Disconnect the sender gauge connector.


b.

Remove the 5 screws and sender gauge.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge.



c.

Remove the gasket from the sender gauge.