1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat:
Remove the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat assembly LH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL).
4.REMOVE FRONT SEAT ASSEMBLY RH
for Manual Seat:
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat assembly RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL).
Use the same procedures described for the LH side.
71692H
5.REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER
71692K
6.REMOVE REAR NO. 5 SEAT CUSHION HINGE COVER
71691H
7.REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER
71691K
8.REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER
9.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
71691E
10.REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER
71691J
11.REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER
71691E
12.REMOVE REAR NO. 1 SEAT CUSHION HINGE COVER
71691J
13.REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER
14.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
55318C
15.REMOVE INSTRUMENT SIDE PANEL LH
55317A
16.REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
55317A
17.REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
67914B
18.REMOVE FRONT DOOR SCUFF PLATE LH
67913B
19.REMOVE FRONT DOOR SCUFF PLATE RH
55606
20.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
62112
21.REMOVE COWL SIDE TRIM BOARD LH
55607
22.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
62111C
23.REMOVE COWL SIDE TRIM BOARD RH
51775
24.REMOVE REAR STEP COVER
67918E
25.REMOVE REAR DOOR SCUFF PLATE LH
67917C
26.REMOVE REAR DOOR SCUFF PLATE RH
87217J
27.REMOVE NO. 2 AIR DUCT PLUG
Detach the 4 claws and remove the 2 plugs.
Use the same procedures for both sides.
87174F
28.REMOVE AIR HEATER GUIDE
Remove the 2 screws and guide.
Use the same procedures for both sides.
87217B
29.REMOVE AIR DUCT PLUG
Detach the 2 claws and remove the plug.
Use the same procedures for both sides.
87174
30.REMOVE REAR AIR DUCT GUIDE
Remove the screw.
Detach the claw and remove the guide.
Use the same procedures for both sides.
71695C
31.REMOVE REAR NO. 1 SEAT PROTECTOR
Detach the clip and 4 claws, and remove the protector.
Use the same procedures to remove the protector on the other side.
71696
32.REMOVE REAR NO. 2 SEAT PROTECTOR
Detach the clip and 4 claws, and remove the protector.
Use the same procedures to remove the protector on the other side.
88520
33.REMOVE COOLING BOX ASSEMBLY (w/ Cool Box)
Remove the cooling box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>REMOVAL).
58901A
34.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
Remove the rear console box sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>REMOVAL).
58510D
35.REMOVE FRONT FLOOR CARPET ASSEMBLY
Detach the 2 clips and 8 claws.
Remove the carpet from the floor, open the back door and tail gate, and remove the carpet from the rear of the vehicle.
86280
36.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
Disconnect the 3 connectors.
Remove the 3 bolts and remove the amplifier with bracket.
86287B
37.REMOVE AMPLIFIER COVER
Detach the 3 clips and remove the cover.
86285
38.REMOVE NO. 1 AMPLIFIER BRACKET
Remove the 2 screws and bracket.
86286
39.REMOVE NO. 2 AMPLIFIER BRACKET
Remove the 2 screws and bracket.