1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect the cables from the negative (-) main battery and sub-battery terminals.
71300S
3.REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)
71400S
4.REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)
5.REMOVE REAR NO. 2 SEAT ASSEMBLY
for Face to Face Seat Type:
(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL)
except Face to Face Seat Type:
(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL)
51775
6.REMOVE REAR STEP COVER
67918E
7.REMOVE REAR DOOR SCUFF PLATE LH
67917C
8.REMOVE REAR DOOR SCUFF PLATE RH
58574A
9.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
71845B
10.REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)
62520P
11.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
w/ Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL)
w/o Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL)
62510P
12.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
w/ Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL)
w/o Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL)
87217B
13.REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)
87174
14.REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)
58570C
15.SEPARATE REAR FLOOR MAT ASSEMBLY
w/ Rear Air Conditioning System:
Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.
Fold back the rear floor mat assembly so that the rear No. 7 air duct can be removed.
w/o Rear Air Conditioning System:
Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.
Fold back the rear floor mat assembly so that the service hole cover can be removed.
87212L
16.REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)
Detach the 4 clips and remove the rear No. 7 air duct.
58325E
17.REMOVE REAR FLOOR SERVICE HOLE COVER
83320B
18.REMOVE FUEL SENDER GAUGE ASSEMBLY
Disconnect the fuel sender gauge connector.
Remove the 5 screws and fuel sender gauge assembly.
Be careful not to bend the arm of the fuel sender gauge assembly.
Remove the gasket from the fuel sender gauge assembly.