Home › Engine / Hybrid System › 1VD-FTV (INTAKE / EXHAUST) › TURBO MOTOR DRIVER › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052790 1VD-FTV INTAKE / EXHAUST _0255174 TURBO MOTOR DRIVER A

1VD-FTV INTAKE / EXHAUST  TURBO MOTOR DRIVER  INSTALLATION  


PROCEDURE

Hide 89878 1.INSTALL TURBO MOTOR DRIVER

a.
U163766E02
3.083,2.354 3.208,2.5 0.125,0.146 10 false A

Insert the bracket tab into the slot labeled A and insert the 2 stud bolts into the bracket as shown in illustration.

NOTICE:

If the turbo motor driver has been struck or dropped, replace it.



b.

Install the 2 nuts and bolt.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)


c.
A329752

Connect the connector. Then move the lock lever as shown in the illustration to lock the connector.


Hide 53805 3.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).