Home › Engine / Hybrid System › 1VD-FTV (INTAKE / EXHAUST) › TURBO MOTOR DRIVER › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052790 1VD-FTV INTAKE / EXHAUST _0255174 TURBO MOTOR DRIVER A

1VD-FTV INTAKE / EXHAUST  TURBO MOTOR DRIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53805 3.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 89878 5.REMOVE TURBO MOTOR DRIVER

a.
U163765E02
1.781,1.146 1.781,0.167 1.781,0.167 1.948,0.167 true 2.083,1.104 2.208,1.25 0.125,0.146 10 false 1 1.583,1.771 1.708,1.917 0.125,0.146 10 false 2 2,0.042 2.333,0.313 0.333,0.271 10 true *a

Disconnect the connector.

Text in Illustration
*a Claw

i.

Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.



b.
A329750

Remove the 2 nuts, bolt and turbo motor driver.

NOTICE:

If the turbo motor driver has been struck or dropped, replace it.