83520
1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not allow adhesive to contact the oil hole.
| *1 | Oil Hole |
Install the oil pressure sender gauge.
Do not start the engine within 1 hour after installation.
Connect the sender gauge connector.
2.INSPECT ENGINE OIL LEVEL
3.INSPECT FOR OIL LEAK
51405A
4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
53806
5.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH