Home › Engine / Hybrid System › 1UR-FE (LUBRICATION) › LUBRICATION SYSTEM
RM2660E _51 Engine / Hybrid System _052797 1UR-FE LUBRICATION _0255208 LUBRICATION SYSTEM G

1UR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the oil and oil filter element (See page Engine / Hybrid System>1UR-FE (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT).


Hide 2.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine. Then stop the engine and wait for 5 minutes.


b.
A297375E03
1.125,1.438 0.802,0.771 0.802,0.771 0.656,0.771 true 0.938,1.573 1.198,1.771 1.198,1.771 1.323,1.771 true 1.333,1.333 1.698,1.5 1.698,1.5 1.802,1.5 true 0.458,0.677 0.635,0.844 0.177,0.167 10 false *a 1.823,1.375 2.042,1.573 0.219,0.198 10 false *c 1.354,1.688 1.573,1.885 0.219,0.198 10 false *b

Check that the engine oil level is between the dipstick low level mark and full level mark.

Text in Illustration
*a Measuring Surface
*b Low Level Mark
*c Full Level Mark

If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

·

If low quality oil or oil of an inappropriate viscosity is used.

·

When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.

·

When leaving the idling for a long time, or when driving frequently through heavy traffic.


When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



Hide 3.INSPECT OIL PRESSURE

a.

Remove the oil pressure sender gauge (See page Engine / Hybrid System>1UR-FE (LUBRICATION)>OIL PRESSURE SENSOR>REMOVAL).


b.
A210000

Install an oil pressure gauge.


c.

Warm up the engine.


d.

Inspect the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idling 70 kPa (0.7 kgf/cm2, 10.1 psi) or higher
2500 rpm 220 kPa (2.2 kgf/cm2, 32 psi) or higher


If the pressure is not as specified, check the oil pump (See page Engine / Hybrid System>1UR-FE (LUBRICATION)>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.


f.

Install the oil pressure sender gauge (See page Engine / Hybrid System>1UR-FE (LUBRICATION)>OIL PRESSURE SENSOR>INSTALLATION).