Home › Engine / Hybrid System › 1UR-FE (LUBRICATION) › OIL PRESSURE SENSOR
RM2660E _51 Engine / Hybrid System _052797 1UR-FE LUBRICATION _0255210 OIL PRESSURE SENSOR A

1UR-FE LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.

Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
U163110E02
2.49,1.094 2.885,1.24 2.885,1.24 2.885,1.344 false 2.802,1.354 2.99,1.552 0.188,0.198 10 false *1

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.


Text in Illustration
*1 Oil Inlet Port


b.

Install the oil pressure sender gauge.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour after installation.



c.

Connect the oil pressure sender gauge connector.


Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53805 5.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53806 6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH