Home › Engine / Hybrid System › 1VD-FTV (LUBRICATION) › OIL PRESSURE SENSOR
RM2660E _51 Engine / Hybrid System _052799 1VD-FTV LUBRICATION _0255221 OIL PRESSURE SENSOR A

1VD-FTV LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.

Remove the adhesive from the threads of the oil pressure sender gauge and the bolt hole of the oil filter bracket.


b.
A161955E01
0.761,0.181 1.403,0.348 0.642,0.166 10 Adhesive 1.919,0.895 1.673,0.285 1.673,0.285 1.516,0.285 false

Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the sensor.



c.
A170281

Install the oil pressure sender gauge.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour after installation.



d.

Connect the oil pressure sender gauge connector.


Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53805 6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 53808A 7.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH