The ECM detects a cruise control switch signal and sends it to the combination meter via the CAN communication line. Then the cruise control indicator light comes on.
The cruise control indicator light circuit uses the CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
Using the intelligent tester, perform the Active Test (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light operation | OFF or ON | - |
Indicator light comes on/goes off.
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER(w/ Multi-information Display)>REMOVAL)
Using the intelligent tester, read the Data List (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| CCS Indicator M-CPU | Cruise control indicator light (Main CPU) / ON or OFF | ON: Cruise control indicator light on
OFF: Cruise control indicator light off |
- |
The intelligent tester display changes according to condition of cruise control indicator light.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1UR-FE) | B |
| NG (for 3UR-FE) | C |
A
(See pageEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE)
B
C