Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P0500  Vehicle Speed Sensor Malfunction  


DESCRIPTION

The speed sensor detects the wheel speed and sends the appropriate signals to the master cylinder solenoid (skid control ECU). The master cylinder solenoid (skid control ECU) converts these wheel speed signals into a 4-pulse signal and outputs it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of these pulse signals.

DTC Code DTC Detection Condition Trouble Area
P0500 The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds. or more while cruise control is in operation.
·

Vehicle speed sensor signal circuit

·

Vehicle speed sensor

·

Combination meter

·

ECM



WIRING DIAGRAM

E149015E05
1.26,2.146 2.531,2.323 1.271,0.177 10 false Combination Meter 5.375,2.354 5.813,2.521 0.438,0.167 10 false ECM 5.375,2.01 5.802,2.177 0.427,0.167 10 false A38*1 5.375,2.188 5.802,2.354 0.427,0.167 10 false A53*2 0.063,2.375 0.885,2.635 0.823,0.26 10 false *2: for RHD 0.063,2.125 0.885,2.385 0.823,0.26 10 false *1: for LHD 1.25,1.99 1.458,2.156 0.208,0.167 10 false E7 4.958,1.198 5.292,1.365 0.333,0.167 10 false SPD 2.313,1.229 2.51,1.396 0.198,0.167 10 false +S 4.656,1.094 4.844,1.26 0.188,0.167 10 false 13 2.625,1.094 2.74,1.26 0.115,0.167 10 false 4

CAUTION / NOTICE / HINT

This DTC code may be output under the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.

PROCEDURE

1.CHECK DTC (CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

With the shift lever in D, drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).



d.

Result
Result Proceed to
OK A
NG (for 1UR-FE) B
NG (for 3UR-FE) C


A

B

C