Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1615  Communication Error from Distance Control ECU to ECM  


DESCRIPTION

The ECM sends the cruise control main switch signal, vehicle speed signal, etc. to the distance control ECU. The distance control ECU sends the acceleration signal, deceleration request signal, etc. to the ECM. The ECM controls cruise control according to these signals.

DTC Code DTC Detection Condition Trouble Area
P1615 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the data sent from the distance control ECU to the ECM is abnormal.
·

Distance control ECU

·

CAN communication system

·

ECM



WIRING DIAGRAM

E149011E04
0.859,2.361 2.828,2.629 1.969,0.268 10 : CAN Communication Line 1.176,1.605 2.725,1.933 1.549,0.328 10 Distance Control ECU 5.391,1.604 5.825,1.834 0.434,0.230 10 ECM 4.965,0.466 5.399,0.696 0.434,0.230 10 CANH 4.965,0.972 5.399,1.202 0.434,0.230 10 CANL 2.078,0.466 2.512,0.696 0.434,0.230 10 CANH 2.078,0.972 2.512,1.202 0.434,0.230 10 CANL

CAUTION / NOTICE / HINT

NOTICE:

When the distance control ECU is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DISTANCE CONTROL ECU>INITIALIZATION).


PROCEDURE

1.REPLACE DISTANCE CONTROL ECU
a.

Replace the distance control ECU with a new one (See page Engine / Hybrid System>CRUISE CONTROL>DISTANCE CONTROL ECU>REMOVAL).




NEXT

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.



d.

Result
Result Proceed to
OK A
NG (for 1UR-FE) B
NG (for 3UR-FE) C


A

END

B

C