Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1630  Communication Error from VSC to ECM  


DESCRIPTION

The distance control ECU sends brake control request signals, warning request signals, etc. to the master cylinder solenoid (skid control ECU) through the ECM. Based on these signals, the brake actuator operates and the warning buzzer sounds. The master cylinder solenoid (skid control ECU) sends brake system malfunction signals, etc. to the ECM.

DTC Code DTC Detection Condition Trouble Area
P1630 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the data sent from the master cylinder solenoid (skid control ECU) to the ECM is abnormal.
·

Master cylinder solenoid (skid control ECU)

·

CAN communication system

·

ECM



WIRING DIAGRAM

E349406E01
2.104,0.583 2.719,0.781 0.615,0.198 10 false CANH 2.146,1.094 2.76,1.292 0.615,0.198 10 false CANL 4.917,0.573 5.531,0.771 0.615,0.198 10 false CANH 4.906,1.083 5.521,1.281 0.615,0.198 10 false CANL 5.375,1.656 5.99,1.854 0.615,0.198 10 false ECM 1.042,1.635 2.667,2.042 1.625,0.406 10 false Master Cylinder Solenoid (Skid Control ECU) 0.885,2.49 3.042,2.771 2.156,0.281 10 false : CAN Communication Line

PROCEDURE

1.REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)
a.

Replace the master cylinder solenoid (skid control ECU) with a new one (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>REMOVAL for LHD, Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>REMOVAL for RHD).



NEXT

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.



d.

Result
Result Proceed to
OK A
NG (for 1UR-FE) B
NG (for 3UR-FE) C


A

END (MASTER CYLINDER SOLENOID [SKID CONTROL ECU] IS DEFECTIVE)

B

C