Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The distance control ECU sends brake control request signals, warning request signals, etc. to the master cylinder solenoid (skid control ECU) through the ECM. Based on these signals, the brake actuator operates and the warning buzzer sounds. The master cylinder solenoid (skid control ECU) sends brake system malfunction signals, etc. to the ECM.

DTC Code DTC Detection Condition Trouble Area
P1631 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the data sent from the ECM to the master cylinder solenoid (skid control ECU) is abnormal.
·

Master cylinder solenoid (skid control ECU)

·

CAN communication system

·

ECM



WIRING DIAGRAM

E349406E01
2.104,0.583 2.719,0.781 0.615,0.198 10 false CANH 2.146,1.094 2.76,1.292 0.615,0.198 10 false CANL 4.917,0.573 5.531,0.771 0.615,0.198 10 false CANH 4.906,1.083 5.521,1.281 0.615,0.198 10 false CANL 5.375,1.656 5.99,1.854 0.615,0.198 10 false ECM 1.042,1.635 2.667,2.042 1.625,0.406 10 false Master Cylinder Solenoid (Skid Control ECU) 0.885,2.49 3.042,2.771 2.156,0.281 10 false : CAN Communication Line

PROCEDURE

1.REPLACE ECM
a.

for 1UR-FE:

i.

Replace the ECM with a new one (See page Engine / Hybrid System>1UR-FE (ENGINE CONTROL)>ECM>REMOVAL).



b.

for 3UR-FE:

i.

Replace the ECM with a new one (See page Engine / Hybrid System>3UR-FE (ENGINE CONTROL)>ECM>REMOVAL).




NEXT

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.



d.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
OK
(DTC P1631 is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C



A

END (ECM IS DEFECTIVE)

B

REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)

C

REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU)