Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052804 CRUISE CONTROL _0255251 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1575  Warning Buzzer Malfunction  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
P1575 The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the approach warning buzzer malfunctions.
·

Vehicle stability control system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

This DTC code may be output under the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BUZZER)
a.

Using the intelligent tester, perform the Active Test (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRAC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Skid control buzzer sounds OFF or ON -

OK:

Skid control buzzer sounds.




OK

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)

NG

GO TO VEHICLE STABILITY CONTROL SYSTEM (Skid Control Buzzer Circuit)

2.CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.



c.

Perform the following to make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.


i.

Drive the vehicle at a speed of 50 km/h (30 mph) or more.


ii.

Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.



d.

Result
Result Proceed to
OK A
NG (for 1UR-FE) B
NG (for 3UR-FE) C


A

B

C