Home › Drivetrain › AB60F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM (for 1VD-FTV) › from 2015.08
RM2660E _52 Drivetrain _052805 AB60F AUTOMATIC TRANSMISSION / TRANSAXLE _0255265 AUTOMATIC TRANSMISSION SYSTEM(for 1VD-FTV) J

AB60F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM(for 1VD-FTV)  L4 Position Switch Circuit  


DESCRIPTION

The 4 wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM. The 4 wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator.

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - BODY GROUND)
a.
U164576E01
0.055,0.002 2.463,0.370 2.408,0.367 10 Front view of wire harness connector: (to 4 Wheel Drive Control ECU) 1.579,1.132 1.954,1.365 0.375,0.233 10 A27 2.649,2.656 2.908,2.858 0.258,0.202 10 L4 2.785,2.641 2.419,1.975 false

Disconnect the 4 wheel drive control ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A27-16 (L4) - Body ground Always 10 kΩ or higher




OK

NG

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - ECM)
2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - ECM)
a.
U164902E02
2.771,3.177 2.406,2.125 false 0.052,3.781 0.844,3.958 0.792,0.177 10 false *1: for LHD 0.052,4.198 0.844,4.375 0.792,0.177 10 false *2: for RHD 1.677,1.417 2.052,1.646 0.375,0.229 10 false A52 1.677,1.104 2.052,1.333 0.375,0.229 10 false A38 2.073,1.375 2.271,1.573 0.198,0.198 10 false *2 2.073,1.073 2.271,1.271 0.198,0.198 10 false *1 0.104,0.083 2.51,0.448 2.406,0.365 10 false Front view of wire harness connector: (to ECM) 2.49,3.156 3.021,3.354 0.531,0.198 10 false 19 (L4)

Disconnect the ECM connector.


b.

Disconnect the 4 wheel drive control ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
A38-19 (L4) - Body ground Always 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
A52-19 (L4) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR