51442
1.REMOVE NO. 2 ENGINE UNDER COVER
51440
2.REMOVE OIL PAN PROTECTOR ASSEMBLY
3.DRAIN AUTOMATIC TRANSMISSION FLUID
Using a 5 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transmission assembly and drain the automatic transmission fluid.
Using a 5 mm hexagon socket wrench, remove the transmission oil pan tube from the automatic transmission assembly and drain the automatic transmission fluid.
| *1 | Transmission Oil Pan Tube |
| *a | Overflow Plug Hole |
| *b | 5 mm Hexagon Socket Wrench |
Using a 5 mm hexagon socket wrench, install the transmission oil pan tube to the automatic transmission assembly.
Using a 5 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the automatic transmission assembly.
35106
4.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
Remove the 11 bolts, automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket.
Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all the pan bolts, and carefully remove the automatic transmission oil pan sub-assembly.
Remove the 4 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.
Examine the particles in the automatic transmission oil pan sub-assembly.
Collect any steel chips with the removed transmission oil cleaner magnets. Carefully look at the foreign objects and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to guess the type of wear which might be found in the transmission.
Result:
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bush wear
35330
5.REMOVE VALVE BODY OIL STRAINER ASSEMBLY
Remove the 4 bolts and valve body oil strainer assembly from the transmission valve body assembly.
Be careful as some fluid will come out of the valve body oil strainer assembly.
Remove the O-ring from the valve body oil strainer assembly.
35410
6.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Remove the bolt, lock plate and ATF temperature sensor.
| *1 | Lock Plate |
| *2 | ATF Temperature Sensor |
| *3 | Transmission Revolution Sensor (NT) Connector |
| *a | Protective Tape |
Remove the O-ring from the ATF temperature sensor.
Using a screwdriver, disconnect the transmission revolution sensor (NT) connector.
Tape the screwdriver tip before use.
Disconnect the 9 connectors from the solenoid valves.
Remove the 14 bolts and transmission valve body assembly.