43420
1.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the lip of the differential oil seal with MP grease.
Inspect the oil seal for wear or damage.
Coat the spline of the inboard joint shaft assembly with hypoid gear oil.
Align the shaft splines and install the drive shaft with a brass bar and hammer.
Set the snap ring with the opening side facing downward.
Be careful not to damage the oil seal.
If the outboard joint shaft is new, remove the anti-rust oil on the screw end with non-residue solvent.
Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when tapping in the shaft.
2.INSTALL FRONT AXLE ASSEMBLY LH
3.ADD DIFFERENTIAL OIL
53806
4.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
5.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
51442
6.INSTALL NO. 2 ENGINE UNDER COVER
51405A
7.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY